Southwest Michigan field crops update – July 11, 2024

Large rainfall accumulations halted fieldwork and resulted in standing water in many fields. Most soybeans reached reproductive stages, and low levels of tar spot were confirmed in Branch County.

A field of soybeans.
Photo by Nicolle Ritchie, MSU Extension.

Weather

While last week saw frequent but light precipitation, coming out of the weekend precipitation became much heavier. Rainfall from the effects of Hurricane Beryl resulted in large precipitation accumulations, including over 4 inches in 24 hours in some areas. As the storm moved from the southwest corner of the state to the northeast, our region got hit harder than other parts of the state. Many fields have standing water. The article “Crops Under Water – Crop Stage is Critical for Recovery” from Ohio State University Extension outlines the expected effects of saturated soils on different crops by crop stage.

This upcoming week will see a frontal system over the weekend that is expected to drop up to an inch of water, followed by scattered showers and high dewpoints. Overall, the weather is still warmer than average, and crops continue to be ahead of historic.

10 day WU forecast as of 7-11.png
Ten-day Weather Underground forecast as of July 11, 2024.
6-10 and 8-14 as of 7-11.png
The 6-10 day (July 16-20, top) and 8-10 day (July 18-24, bottom) outlooks for temperature (left) and precipitation (right).
Jan-Jun departure from average.png
The mean temperature departure from average from January to June 2024. Michigan is about 5 degrees Fahrenheit above the historic average.

Crops and pests

Soybeans range from late vegetative stages to R4. Most soybeans are at R1 to R2 right now. According to the Michigan State University Extension article, “Identifying soybean reproductive growth stages,” a field reaches R1 when at least 50% of plants have an open flower at any node on the main stem. R2 is identified by one open flower on one of the two uppermost nodes that have a fully developed leaf, meaning the leaf is unfurled and the edges are no longer touching. R3 begins when any of the four uppermost nodes with a fully developed leaf has one pod of just under 0.25 inches (3/16 inches to be precise). At R4, one pod on any of the four uppermost nodes (with a fully developed leaf) is 0.75 inches long.

Soybean pod R3 3-16in 2.jpg
This soybean pod found on the fourth node (with a fully developed leaf) on the main stem is 3/16 inches long, meaning the soybean plant has reached R3. Photo by Nicolle Ritchie, MSU Extension.

White mold fungicide applications should occur between R1 and R3. The Sporecaster app shows high white mold risk for today, July 11, in the westernmost counties and moderate risk farther inland. “Fungicide use for managing white mold in soybeans” from Michigan State University (MSU) Extension lays out some of the considerations for deciding to apply a fungicide for white mold or not. Phytophthora root rot also becomes a risk with the heavy rainfall, so keep an eye out for it in fields and send in samples to MSU Plant and Pest Diagnostics as needed.

Sporecaster WM risk 7-11.png
Soybean white mold risk from the Sporecaster app, based on 15-inch rows, flowers present and over canopy threshold. A risk score of 40% or higher during flowering implies a white mold spray may be warranted.

Corn has continued to tassel and some acres have now reached R1 (silks extend outside of husk leaves), primarily in earlier planted commercial corn. Relatively few seed corn acres have begun to tassel. With all the rain this week, nitrogen was at risk of leaching out of the root zone, depending on the rainfall and nitrogen application timing. In some cases, it may be necessary to sidedress more nitrogen (if the corn is short enough to allow equipment to pass), fertigate or fly dry fertilizer to address nitrogen deficiencies.

Corn R1 silk 2.jpg
Commercial corn at R1. On the ear, silks extend outside of husk leaves, and the tassel is fully emerged and flowering. Photo by Nicolle Ritchie, MSU Extension.

Tar spot has been found at low levels in Branch County and a couple others in eastern Michigan. The Tarspotter app shows that the tar spot risk for today, July 11, is down a little bit from last week, with most counties at moderate risk. Scout your fields to determine if a fungicide is needed. If applying a single fungicide application to manage tar spot, target VT to R3.

Tarspotter tar spot risk 7-11.jpg
Corn tar spot risk from the Tarspotter app. The app sets a default risk score of 35% or higher between VT to R3 to imply a tar spot spray may be warranted.

Western bean cutworm moths continue to fly, and the highest counts from the bucket traps this week were found in Cass County near Cassopolis, Michigan. Corn is most attractive for egg laying between pretassel and full tassel. Bucket traps in Branch (near Union City), Berrien (near Eau Claire), Cass (near Cassopolis) and St. Joseph (Centreville and Sturgis) counties have caught the following:

Date

Berrien

Cassopolis

Centreville 1

Centreville 2

Sturgis

Union City 1

Union City 2

6/24

2

0

6

9

0

5

3

7/1

1

81

29

46

29

61

4

7/8

4

123

40

34

22

90

31

WBC moth better cropped.jpg
Western bean cutworm moth. Note the crescent shaped marking, tan dot and white outer stripe on the wing. Photo by Nicolle Ritchie, MSU Extension.

Some winter wheat remains unharvested due to the moisture received this past week. Wheat that sits in the field too long and with sufficient precipitation runs the risk of preharvest sprout.

Aphids are present on potatoes. Risks for both vine rot and tuber pathogen inoculation increased this past week due to the precipitation. Saturated soils cause lenticels (sites of gas exchange on the tuber) to swell and rupture to allow more oxygen into the tuber. Even after visible swelling of the lenticels goes down, it can take around a week for them to fully heal.

Potatoes aphids Miguel Raya.JPG
Aphids on the underside of a potato leaflet. Photo by Miguel Raya, crop scout.

Alfalfa and forage cutting and baling has been delayed throughout the region due to the moisture received this past week. Some alfalfa has started to bloom, reducing hay quality. If you’re interested in more tips and information on forage management given recent weather conditions, check out the most recent Field Crops Virtual Breakfast Series on Wild Weather for Hay.

Weekly water use

Estimated weekly crop water use for field crops in Michigan (inches per week) — Week of July 8 – 14, 2024

Crop

Growth stage

Constantine

Entrican

Hart

Corn

V8

0.69

0.69

0.73

V10

0.93

0.94

0.99

V12

1.23

1.24

1.30

VT

1.35

1.36

1.43

Silk

1.35

1.36

1.43

 

Soybeans

V2 2nd node

0.62

0.62

0.65

V3 3rd node

0.74

0.74

0.78

R1 Beginning bloom

1.23

1.24

1.30

R2 Full bloom

1.35

1.36

1.43

Corn water use remains at its peak during tasseling, and soybeans are still in the R1 and R2 stages, which require crop water use monitoring to avoid water stress. However, for all crops, it is crucial to track the accumulated rainfall received so far this week, as it should have covered the weekly crop water needs.

The table above presents estimated crop water use for various field crops across three locations in Michigan. This data helps irrigation management decisions by showcasing potential crop evapotranspiration, calculated based on reference evapotranspiration and crop coefficients for each crop growth stage. It is crucial to note that crop water use values vary across regions due to differences in weather conditions, growth stages, agronomic practices and soil properties.

When using these values for irrigation scheduling, be mindful that they assume all applied irrigation water will be utilized by the plants without any loss. Additionally, these values do not account for any precipitation that may occur during the week of calculation. For more tools and information on irrigation scheduling tools, please refer to: Irrigation Scheduling Tools.

Reference evapotranspiration data was obtained from MSU Enviroweather, which also offers a model for determining potential crop evapotranspiration. To access this tool, visit Enviroweather, click on "Crops," select your crop and use the potential evapotranspiration tool by choosing your nearest weather station, the latest date of interest and other crop information.

Field Crops Virtual Breakfast Series

VB 2024 graphic.jpg

Wild weather for haymaking, presented by Kim Cassida, was the topic for the MSU Extension Field Crops Virtual Breakfast Series this week. Weather extremes cause stress, and too much stress kills forages. Weather also affects hay cutting and baling decisions and impacts hay quality. Recordings of this and all the Virtual Breakfast meetings are closed-captioned and available at the Field Crops Virtual Breakfast webpage and the MSU Extension field crops team social media platforms: Facebook, Spotify, YouTube, Apple Podcasts and Twitter. 

 

 

Did you find this article useful?